top of page

AVIBUS Fan back up thermostat

cb657007-d90c-402d-8c3c-3251154a4d82.png

Variable backup controller for your modbus EC  AVI-AIR FAN ventilators.

The AVI-BUS connects to your master controller of your ventilation system through: modbus or 0-10 volt

 

The AVIBUS aprovides:

  • Visibility of your fan motor status

  • Real-time measurement of ventilation airflow

  • Three back up modes of operation ​

    • MANUAL MODE​

    • SECURITY MODE (last set master command)

    • THERMOSTAT

  • Easy modbus setup with clean interface

​

Screenshot 2026-02-08 at 8.48.03 PM.png

Guaranteed Compatibility

​​

​​

The AVIBUS can also operate as a standalone thermostate 

to operate your EC AVI-AIR fans

The HRVI connects to your ventilation system through:

 

Modbus communication – for full or assisted control

  • Precise visibility into recovery efficiency

  • Real-time measurement of ventilation airflow

  • Predictable cleaning and defrost cycles

  • Optimization options tailored to your operational realities

​

0–10 V signal – to manage the exchanger like a simple ventilation stage

Or simply in standalone mode, for easy temporary or permanent manual control.

Connects to the AVI-HUB or your master via 0-10v 
 

Smart Synchronization:  SyncLink

SyncLink technology, exclusive to Avi-Air, coordinates defrost and cleaning cycles between multiple exchangers to maintain optimal air quality at all times—without ventilation drops or manual intervention.

Screenshot 2026-02-08 at 8.48.03 PM.png

The AVI35 Heat Exchanger Modbus Controller

18549.png

As simple to operate as a fan, yet delivering the energy efficiency of a heat recovery ventilator.

AVI-HUB 13.jpg
gros hub 2_edited.png

AVI-HUB

Innovate and redefine your barn ventilation with AVI-HUB

The efficiency data for each individual AVI35 exchanger is transmitted to the AVI-HUB for analysis. The interface displays the fan runtimes, the recovered intake air temperature, the fan speeds and the sensible heat energy recovered over time.

The AVI-HUB interface connects to your existing farm controller using a 0-10v signal or modbus. The farm controller determines the necessary fan speed or cfm for the group of exchangers, and the HUB relays that information to each HRVI via MODBUS. 

The AVI-HUB gathers temperature data from each HRVI and modifies the fan rpm to ensure consistent room temperatures as needed. The HRVI will boost exchanger  CFM output in warmer areas while decreasing it in cooler zones working to balance all temperature readings. 

bottom of page